Since 1995, Assembling Dependable Engineering, Design, & Manufacturing Relationships
header-image

秒速飞艇公式

Printed Circuit Board Design

秒速飞艇怎么玩的

Unless you are using Gerber274X format files, an aperture list is required for the manufacturer to create the artwork needed for your circuit board design.

Gerber274D format does not automatically include Aperture List information.All circuit board design software that can output in Gerber274D format will also output the Aperture List with one of the following common file extensions: .rep, .apt, and .apr.

秒速飞艇走势图

The drill file is used to determine the size and location of each hole (plated or non-plated thru) in the circuit board design. Most PCB layout packages generate this file. Make sure to include it in the output file set provided to the fabricator.

秒速飞艇开奖网

The tool list should be embedded in your drill file or can be sent as a separate .txt file. Common tool List extensions are .tol and .rep.

秒速飞艇网上投注

You must ensure annularrings meet minimum size requirements. Annular rings are the ‘donut” shaped area of the a connecting via or a plated thru hole. There are minimum size requirements for the width of this area. The minimum annular ring should be 0.005″ for vias and 0.007″ for component holes.

秒速飞艇开奖软件

There must be sufficient space between two adjacent copper features to avoid shorts, arcing or fabrication issues. Minimum spacing for manufacturing is generally 0.005″, but varies for different fabricators and may incur a premium charge if less than 0.007.″

秒速飞艇人工计划软件

Insufficient spacing between the edge of a hole and internal copper may cause shorts or other issues. Generally a minimum of 0.010″ space between the internal copper feature and adjacent drill hole is required, but 0.015″ is preferred.

SG赛车历史记录 澳洲10开奖结果 秒速赛车三期计划 秒速赛车平台 秒速飞艇公式 SG赛车开奖最快结果 SG赛车开奖官方同步