Since 1995, Assembling Dependable Engineering, Design, & Manufacturing Relationships
header-image

秒速飞艇计划软件

printed circuit board

秒速飞艇现场开奖结果

A common problem is often junction box panels with PCB assemblies which end up being exposed to condensation due to the sealed enclosure, and temperature/humidity issues. If the condensation is great enough, it drips onto the electronics from the inside of the enclosure causing corrosion or electrical shorts.

Several options can be considered to prevent / eliminate such damage.

Traditional conformal coatings are a common surface treatment proving limited protection from corrosion and electrical shorts. While they are not designed to protect boards from large water drops or condensing moister, they do keep water drops off the board for short periods of time (~10 minutes). Any longer and water may permeate the coating. This is the least expensive and most common, but also offers the lease effective water protection. However, if all you are concerned about is non-condensing humidity it may be a good solution.

pcb Newer conformal coatings are the vapor deposition or nano-coating types. Often cell phone manufacturers use these types of coatings because they can get between ultra tiny parts. They can be very inexpensive for very high volumes (>1 million per year) of small boards. They require special handling of the boards afterwards since the coating is easily damaged.

The next level of protection may be encapsulants, such as potting compounds, epoxy resins, etc. They can be applied over just one component, one entire side of the printed circuit board assembly or over the entire board. This is basically a plastic waterproof covering. It’s common for small, inexpensive devices, which must survive very wet environments, to be entirely submerged (potted). Sometimes only one side of the board is coated like a more robust traditional conformal coating. Keep in mind though that the bare PCB substrate is glass fiber and absorbs moisture. So if the environment is humid, over time the water will be able to corrode the traces from the inside unless the entire board is protected.

pcb

These materials have a range of properties (such as hardness, thermal expansion, etc.). This work well for low and high volume applications and may be inexpensive if the required volume is low and easy to apply.

For many automotive applications, the PCB assembly is placed in a waterproof enclosure and filled with a soft potting compound. This not only provides two layers of protection, but prevents damage caused by temperature swings creating large pressure differentials in the unused air space.

If your enclosure is too large to fill with an encapsulant, but is water tight, it’s important to allow for these pressure changes by using a pressure relief valve to prevent moisture from condensing.

澳洲幸运5冷热号统计 澳洲幸运10最准的计划 澳洲10开奖结果 SG飞艇官方开奖查询 澳洲幸运10网上